Weber DGV Carburetor Cold Air Intake Box

I have fabricated and installed a prototype (proof of concept) cold air intake box using a K&N air filter. This should get away from the "furnace-like" air going into the carburetor, thereby increasing power.

This one was cut by hand, bent and fitted. The final version will possibly be cut from stainless steel and welded.

So far it works well. I realize that I said YEARS AGO that I would rebuild it , get specific with measurements, and put a drawing on the site.  So far (obviously) I have not.  Many have been asking about it and I realize I need to do that.  I promise I will soon, now that the site has been reworked.

At this point, I'm not sure if there is any more power, but it is different and getting a lot of attention.